NOTICE: Important OS support information after April 2023 Live with the Experts | Live from the Birmingham Technology Center!Ĭheck out the following video to see the latest and greatest in Fusion 360. We made many asset management improvements and addressed multiple CERs in the Electronics workspace.This is now fixed, and the pads should display as expected. Previously, if the pads in Fusion 360 Electronics were rotated (but not with 90 degrees) and the polygon edges are also with some angle, the pad (with the same signal as polygon) was displayed as a gap/cutout.A few of you on the forums reported a graphics issue in Fusion 360 Electronics where a black screen would be displayed instead of the Schematic and Board design areas.We fixed an issue within wrap 2D Contour where trimming a chain and setting the negative value for start/end extensions would cause an error.A few of you on the forums reported an issue where high DPI scaling was not working as intended.We fixed an issue where the Viewcube was displayed incorrectly in non-English languages.This workflow is now fixed, and you will be able to accurately name your exported mesh files with ease. This change made it so you had to rewrite your part names when exporting STL files.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |